Protect your spectrum analyzer input during conducted emissions testing with a Com-Power transient limiter. The following products can be used during EMC conducted emissions testing to protect the input of a spectrum analyzer. Combined in both the LIT-153A and LIT-930A Transient Limiters are a low-pass filter, high pass filter, transient suppressors and two separate 5 dB impedance matching attenuation pads; one at the input and one at the output. Follow the links on this page for more information about either of our spectrum analyzer transient limiters. You also can contact us for pricing and other information.
LIT-153A - Prevent Damage to Instrument Input from Transient Voltage Spikes
The LIT-153A transient limiter works over the frequency range of 150 kHz to 30 MHz. It provides excellent protection against high level transients coming from the Line Impedance Stabilization Network (LISN); which, if powerful enough, could p...
LIT-930A - For conducted emissions testing with LISN
The LIT-930A features a broader frequency range than the LIT-153A, in that the low end of the its operation extends down to 9 kHz. The un...
Other EMC Test Equipment
- Absorbing Clamps
- Antenna Kits
- Antenna Masts - Automated and Manual
- Antennas
- CDNs - Coupling Decoupling Network
- Comb Generators
- Conducted Immunity Test Systems
- Discontinued Products
- EM Clamps
- Feed Through Capacitor
- ISNs - Impedance Stabilization Network
- Line Impedance Stabilization Networks
- Magnetic Field Generator
- Near Field Probes
- Power Amplifiers
- Pre-compliance Emissions Test Systems
- Preamplifiers
- RF Current & BCI Probes, Calibration Fixtures
- Spectrum Analyzers
- Surge Generators
- System Controllers
- Transient Limiters
- Tripods For EMC
- Turntables
